Q&A about corset making

Frequently asked questions from customers about products and services.

Victoria corset project

Posted on

0 Comments

Victoria steelboned corset

 

Here's a corset I made recently when testing out a few components on site, not least the recently released Victoria mid bust corset pattern.  I've adapted the pattern slightly by changing the shape of the top line slightly, and adding some suspenders.  I re-drew the bottom line of the corset so that at each point where I wanted a suspender, the line flowed nicely into the elastic ends.  That's all I did, so it was pretty easy peasy.  

It's a single layer corset - the boning channels are made from scraps of the same coutil (offcuts from cutting out the pattern!).  These are cut into 2.5cm strips and then run through the Prym bias binding maker to make boning channels.  I cut the coutil on the straight grain as this is best for scrap use and for stronger boning channels, however if you had a particularly deep curve over the hip (using another pattern perhaps) then you may want to use a bias grain for your self made bone channels.

With regard to sizing of the Sew Curvy patterns, go with the waist size first - it is easier to adjust the top (bust) and bottom (hip) than it is to use the correct size for those and then adjust the waist - so this is opposite to what a normal dressmaking pattern will tell you.

The components I used for this project are all listed with links here:

back of the Victoria corset

Add a comment:

Leave a comment:

Comments

Add a comment